Installation

3UR-FE ENGINE CONTROL: POWER STEERING OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL POWER STEERING OIL PRESSURE SWITCH

(a) Install a new O-ring to the oil pressure switch.

(b) Apply a light coat of engine oil to the O-ring of the oil pressure switch.

NOTICE:
* When reusing the oil pressure switch, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the new O-ring.

(c) Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)





(d) Connect the oil pressure switch connector.

2. INSTALL FAN & GENERATOR V BELT Installation

3. INSTALL AIR CLEANER ASSEMBLY Installation

4. INSTALL AIR CLEANER HOSE ASSEMBLY Installation

5. ADD POWER STEERING FLUID

6. BLEED POWER STEERING FLUID Power Steering System

7. INSPECT FOR POWER STEERING FLUID LEAK

8. INSTALL FRONT FENDER APRON SEAL FRONT RH Installation

9. INSTALL FRONT WHEEL

10. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

11. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation

12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Installation

13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Installation