Installation
FRONT SUSPENSION: FRONT STABILIZER BAR (for 2WD): INSTALLATION
NOTICE:
When disconnecting the steering intermediate shaft assembly and pinion shaft of steering link assembly, be sure to place matchmarks before servicing.
1. INSTALL FRONT STABILIZER BAR
(a) Install the front stabilizer bar from the left side of the vehicle.
2. INSTALL STEERING LINK ASSEMBLY (for 1AR-FE) Installation
3. INSTALL FRONT NO. 1 STABILIZER BAR BUSHING
(a) Install the 2 front No. 1 stabilizer bar bushings to the front stabilizer bar as shown in the illustration.
Text in Illustration
NOTICE:
When installing the front No. 1 stabilizer bar bushings, make sure that the cutout faces the rear of the vehicle.
4. INSTALL FRONT NO. 2 STABILIZER BRACKET LH (for 1AR-FE)
(a) Install the front No. 2 stabilizer bracket LH to the front No. 1 stabilizer bar bushing.
5. INSTALL FRONT NO. 2 STABILIZER BRACKET RH (for 1AR-FE)
HINT
Perform the same procedure as the LH side.
6. INSTALL FRONT NO. 1 STABILIZER BRACKET LH
(a) Install the front No. 1 stabilizer bracket LH to the front frame assembly with the 2 bolts.
Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)
7. INSTALL FRONT NO. 1 STABILIZER BRACKET RH
HINT
Perform the same procedure as the LH side.
8. INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY (for 1AR-FE) Installation
9. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation
10. INSTALL FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH Installation
11. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the front stabilizer link assembly LH with the nut.
Torque : 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
12. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT
Perform the same procedure as the LH side.
13. CONNECT TIE ROD ASSEMBLY LH Installation
14. CONNECT TIE ROD ASSEMBLY RH (for 1AR-FE)
HINT
Perform the same procedure as the LH side.
15. INSTALL FRONT SPEED SENSOR LH Installation
16. INSTALL FRONT AXLE SHAFT NUT LH Installation
17. INSTALL FRONT EXHAUST PIPE ASSEMBLY (for 1AR-FE) Installation
18. INSTALL FRONT WHEELS
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
19. INSPECT FOR EXHAUST GAS LEAK (for 1AR-FE)
20. INSPECT SPEED SENSOR SIGNAL
Test Mode Procedure
21. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
Front Wheel Alignment