Removal

A750F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY

3. REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)

4. DISCONNECT OXYGEN SENSOR

5. REMOVE EXHAUST PIPE

Removal

6. REMOVE PROPELLER SHAFT ASSEMBLY FRONT

7. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

8. DRAIN AUTOMATIC TRANSMISSION FLUID

(a) Remove the drain plug and gasket, and drain ATF.

(b) Install a new gasket and drain plug.

Torque : 28 Nm (285 kgf-cm, 21 ft-lbf)

9. REMOVE MANIFOLD STAY





(a) Remove the 3 bolts and manifold stay.

10. REMOVE NO.2 MANIFOLD STAY





(a) Remove the 3 bolts and manifold stay No. 2.

11. DISCONNECT NO.1 OIL COOLER INLET TUBE





(a) Remove the 3 bolts and 2 clamps.

(b) Using a union nut wrench, disconnect the oil cooler inlet tube No. 1.





12. DISCONNECT NO.1 OIL COOLER OUTLET TUBE

(a) Using a union nut wrench, disconnect the oil cooler outlet tube No. 1.

13. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Remove the nut and disconnect the transmission control cable.

(b) Remove the 2 bolts and disconnect the transmission control cable.

14. SUPPORT AUTOMATIC TRANSMISSION WITH TRANSFER





(a) Support the automatic transmission assembly with a transmission jack.

15. REMOVE NO.3 FRAME CROSSMEMBER SUB-ASSEMBLY





(a) Remove the 4 bolts on the frame crossmember sub-assembly No. 3.

(b) Remove the 4 nuts, 4 bolts and frame crossmember sub-assembly No. 3.

16. REMOVE REAR NO.1 ENGINE MOUNTING INSULATOR





(a) Remove the 4 bolts and engine mounting insulator rear from the automatic transmission.

17. DISCONNECT CONNECTOR

(a) Disconnect the park/neutral position switch connector.

(b) Disconnect the transmission wire connector.

(c) Disconnect the 2 speed sensor connectors.

(d) Disconnect the transfer shift actuator connector.

(e) Disconnect the indicator switch No. 1 connector.

(f) Disconnect the indicator switch No. 2 connector.

18. DISCONNECT WIRE HARNESS

19. REMOVE STARTER ASSEMBLY Removal

20. REMOVE FLYWHEEL HOUSING SIDE COVER





(a) Remove the flywheel housing side cover from the cylinder block.

21. REMOVE AUTOMATIC TRANSMISSION WITH TRANSFER





(a) Turn the crankshaft to gain access to each bolt.

(b) Hold the crankshaft pulley nut with a wrench and remove the 6 bolts.

(c) Remove the 9 bolts.





(d) Separate and remove the automatic transmission.

22. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY

23. REMOVE TRANSFER ASSEMBLY