Installation

3UR-FE COOLING: THERMOSTAT: INSTALLATION

1. INSTALL WATER INLET SUB-ASSEMBLY WITH THERMOSTAT

(a) Install a new gasket and the water inlet with thermostat with the 3 nuts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)





(b) Install the air tube bracket bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)





(c) Connect the No. 5 water by-pass hose.

HINT
Install the hose so that the direction of the hose clamp is as indicated in the illustration.

(d) Connect the air pump connector clamp's holder.





(e) Attach the wire harness clamp.

(f) Connect the air pump connector.

(g) Connect the No. 2 and No. 3 air hoses.

2. CONNECT OUTLET RADIATOR HOSE

3. ADD ENGINE COOLANT Service and Repair

4. INSPECT FOR COOLANT LEAK Testing and Inspection

5. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

6. INSTALL NO. 1 ENGINE UNDER COVER Replacement