Installation

3UR-FE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: INSTALLATION

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR





(a) Install a new gasket to the sensor.

(b) Using a 19 mm ball joint lock nut wrench, install the sensor.

without 19 mm ball joint lock nut wrench - Torque : 20 Nm (200 kgf-cm, 14 ft-lbf)

with 19 mm ball joint lock nut wrench - Torque : 10 Nm (104 kgf-cm, 8 ft-lbf)

(c) Connect the sensor connector.

2. ADD ENGINE COOLANT Service and Repair

3. INSPECT FOR COOLANT LEAK Testing and Inspection

4. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

5. INSTALL NO. 1 ENGINE UNDER COVER Replacement