Air Intake Control Circuit
1AR-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: Air Intake Control Circuit
- Air Intake Control Circuit
DESCRIPTION
The air cleaner is equipped with two inlets, one of which is opened or closed by the Air Intake Control Valve (AICV). This system reduces intake noise and increases engine power at low-to-high engine speed range.
When the engine is operating in the low-to-mid speed range, this control operates the air intake control valve to close one of the air cleaner inlets. When the engine speed is more than 3600 rpm and the opening angle of the throttle valve is more than 60°, the ECM activates the VSV and opens the air intake control valve.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. PERFORM ACTIVE TEST USING TECHSTREAM (ACTIVATE THE VSV FOR AICS)
(a) Disconnect the 2 hoses from the VSV for air intake control valve.
(b) Turn the ignition switch to ON and turn the Techstream on.
(c) Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for AICS.
(d) Check the operation of the VSV when the VSV is operated by the Techstream.
Standard:
NG -- INSPECT VACUUM SWITCHING VALVE (VSV FOR AICV)
OK -- Continue to next step.
2. INSPECT VACUUM TANK
(a) Inspect the vacuum tank Testing and Inspection.
NG -- REPLACE AIR CLEANER CAP SUB-ASSEMBLY
OK -- Continue to next step.
3. INSPECT INTAKE AIR CONTROL VALVE ASSEMBLY
(a) Inspect the intake air control valve assembly On-Vehicle Inspection.
NG -- REPLACE NO. 3 INTAKE AIR CONTROL VALVE ASSEMBLY
OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures
4. INSPECT VACUUM SWITCHING VALVE (VSV FOR AICV)
(a) Inspect the VSV for air intake control valve Vacuum Switching Valve (for Intake Air Control System).
NG -- REPLACE NO. 3 INTAKE AIR CONTROL VALVE ASSEMBLY
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (VSV FOR AICV VOLTAGE)
(a) Disconnect the VSV for air intake control valve connector.
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (EFI NO. 3 FUSE - VSV FOR AIR INTAKE CONTROL VALVE)
OK -- Continue to next step.
6. CHECK HARNESS AND CONNECTOR (VSV FOR AIR INTAKE CONTROL VALVE - ECM)
(a) Disconnect the VSV for air intake control valve connector.
(b) Disconnect the ECM connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance (Check for Open):
Standard Resistance (Check for Short):
(d) Reconnect the ECM connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE ECM Removal