Removal

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: REMOVAL

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below are for the LH side.

1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing Service Precautions.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE RADIATOR GRILLE SUB-ASSEMBLY Removal

5. REMOVE FRONT BUMPER ASSEMBLY Removal

6. REMOVE HEADLIGHT ASSEMBLY Removal

7. REMOVE FRONT AIRBAG SENSOR

(a) Disconnect the connector from the front airbag sensor.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Remove the 2 bolts.

NOTICE:
Loosen the bolt while holding the front airbag sensor because the front airbag sensor claws and pin (stopper) are easily damaged.

(c) Disengage the 2 claws and pin, and remove the front airbag sensor from the body.