Engine Valley Components Overview

Engine Valley Components Overview





1 Input hub

2 8 Nm

3 Clutch

• Phased in introduction of a torsion elastic clutch.

4 50 Nm + 1/4 turn (90°)

• Replace.

5 20 Nm

6 Generator

• Removing and installing

7 Oil filter housing - upper section

8 Coolant connection

• with Engine Coolant Temperature (ECT) Sensor (G62)

• Removing and installing --> [ Coolant Connection ] Coolant Connection

9 Gasket

• Replace

10 Seal

• Replace

11 20 Nm + 1/4 turn (90 °)

• Replace

12 Oil filter housing - lower section

• Oil filter housing assembly overview, refer to --> [ Oil Filter Housing Assembly Overview ] Oil Filter Housing Assembly Overview.

• With coolant thermostat housing assembly overview, refer to --> [ Coolant Thermostat Housing Assembly Overview ] Service and Repair.

13 Cover

14 Noise insulation

• Installation not necessary.

15 Bypass flap with cooler for Exhaust Gas Recirculation (EGR)

• For vehicle with engine code BWF.

• Assembly overview, refer to --> [ Bypass Flap with Cooler Assembly Overview ] Bypass Flap with Cooler Assembly Overview.

16 Fuel filter

• For vehicle with engine code BKW.

17 Alignment bushing

• Secure with commercially available grease, if necessary, before installation.