Selector Mechanism Overview, through 02.09

Selector Mechanism Overview, through 02.09


Move the selector lever into the "P" position and set the parking brake before working with the engine running.






1 Selector Handle with Cover

• Do not remove the handle unnecessarily. For emergency release, only the cover must be unclipped. Refer to => [ Selector Lever, Manual Release ] Procedures.

• Pull the button past its pressure point before removing the handle. Secure the button with a cable tie or some suitable wire. This prevents the button from being pushed back into the handle accidentally.

2 Selector Mechanism

• With the shift lock solenoid (N110).

• Emergency release, refer to => [ Selector Lever, Manual Release ] Procedures.

• Removing and installing:

- Remove the center bracket.

- Remove the cable from transmission. Refer to => [ Selector Lever Cable, through 02.09 ] Service and Repair.

- If necessary: disconnect or remove the exhaust system components.

- Remove the heat shield under the selector mechanism.

- Adjust the selector lever cable after installing. Refer to => [ Selector Lever Cable, Adjusting ] Adjustments.

3 Spring with Bolt

• 3 Nm

4 Pin

• Removing, refer to => [ Selector Lever Cable, through 02.09 ] Service and Repair.

• Do not lubricate

5 Retaining Plate

• Always replace after removing.

6 Nut

• 9 Nm

• Quantity: 4

7 Selector Housing

• With seal.

8 Adjusting Bolt

• 13 Nm

9 Lock Washer

• Always replace after removing.

10 Lock Washer

• Always replace after removing.

11 Selector Lever Cable

• The cable is not lubricated.

• Removing and installing, refer to => [ Selector Lever Cable, through 02.09 ] Service and Repair.

• Checking, refer to => [ Selector Lever Cable, Checking ] Selector Lever Cable, Checking.

• Adjusting, refer to => [ Selector Lever Cable, Adjusting ] Adjustments.

12 Nut

• 8 Nm

• Quantity: 4