Charge Air System Assembly Overview

Charge Air System Assembly Overview

CAUTION!
The charge air hose clamps must be tightened to 5.5 Nm. An insufficient or excessive tightening torque can cause the charge air hose to come off the charge air pipe while driving.

• Noise generator assembly overview, refer to --> [ Noise Generator Assembly Overview ] Noise Generator Assembly Overview.





1 Bolt, 5 Nm

2 Mount

• For the charge air cooler.

3 Charge Air Cooler

• Removing and installing, refer to --> [ Charge Air Cooler ] Charge Air Cooler.

4 Charge Air Pipe

5 Bolt, 10 Nm

6 Charge Air Hose

• Disconnecting and connecting, refer to --> [ Charge Air Hose Connector Coupling, Disconnecting and Connecting ] Charge Air Hose Connector Coupling, Disconnecting and Connecting.

7 Charge Air Pipe

• To the noise generator.

8 Charge Air Hose

• Disconnecting and connecting, refer to --> [ Charge Air Hose Connector Coupling, Disconnecting and Connecting ] Charge Air Hose Connector Coupling, Disconnecting and Connecting.

9 Hose Clamp

10 Charge Air Hose

• To the throttle valve control module.

11 Charge Air Hose

12 Charge Air Pipe

13 Charge Air Hose

14 Bolt, 8 Nm

15 Noise Generator

• Assembly overview, refer to --> [ Noise Generator Assembly Overview ] Noise Generator Assembly Overview.

16 Charge Air Pipe

17 Charge Air Hose

• Disconnecting and connecting, refer to --> [ Charge Air Hose Connector Coupling, Disconnecting and Connecting ] Charge Air Hose Connector Coupling, Disconnecting and Connecting

18 Charge Air Pressure Sensor (G31)

19 Bolt, 5 Nm