B1016

B1016 - Rear Defrost Switch Request Input Circuit Low

For a complete wiring diagram, refer to.

• When Monitored: With the ignition on.

• Set Condition: The rear defrost switch signal circuit is short to ground.






Test Step 1 - Test for Intermittent Condition

• Turn the ignition ON.

• With the scan tool, erase all DTC's.

• Operate the rear defrost switch several times.

• Cycle the ignition from ON to OFF.

• Turn the ignition ON.

• With the scan tool, read DTC's.

Does the scan tool display B1016 Rear Defrost Switch Request Input Circuit Low?

Yes

• Replace the A/C heater control.

• Perform the HVAC Verification Test. Refer to => Non-DTC Based Diagnostics. HVAC Verification Test

No

• The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals. Repair as necessary.

• Perform the HVAC Verification Test. Refer to => Non-DTC Based Diagnostics. HVAC Verification Test