Seat Cushion Frame

Seat Cushion Frame


Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect the negative battery cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions may result in accidental airbag deployment and possible serious or fatal injury.

• Power, heated seat shown. Manual and non-heated seat similar.

Removing






- Remove the seat from the vehicle and place it on a workbench. Refer to => [ Seat ] Seat.

- Remove the seat back. Refer to => [ Seat Back ] Seat Back.

- Remove the seat cushion cover (2), seat cushion (5) and the wire harness (4) (if equipped) from the seat cushion frame (3). Refer to => [ Seat Cover and Cushion ] Seat Cover and Cushion.

- Remove the four power seat track isolators (1) from the bottom of the seat cushion frame, if equipped.

Installing






- If required, install the four power seat track isolators (1) onto the bottom of the seat cushion frame (3). Make sure the isolators are correctly positioned.

- Install the seat cushion (5), seat cushion cover (2) and the wire harness (4) (if equipped). Refer to => [ Seat Cover and Cushion ] Seat Cover and Cushion.

- Install the seat back. Refer to => [ Seat Back ] Seat Back.

- Install the seat. Refer to => [ Seat ] Seat.