Mounting Bracket

Mounting Bracket

Removing:

- Open the storage compartment - 2 - and remove it.






- Remove the bolts - arrows - and the trim panel - 1 - inside the driver footwell.

- Remove the diagnostic connection - 3 -.

- Disconnect the connector from the footwell lamp - 4 -, if equipped.

- Remove the steering column trim.

- Remove the right bolt - 1 - and the brake pedal crash bolster - 2 -.






- Disconnect brake pedal from brake booster. Refer to => [ Brake Pedal and Brake Booster, Separating and Connecting ] Brake Pedal and Brake Booster, Separating and Connecting.

- Remove the threaded connection - arrows - from the brake pedal - 1 -.






- Remove the brake pedal.

- Remove the threaded connection - 1 - between the brake booster and the bracket.






- Remove the threaded connection - 2 - between the bulkhead and the bracket.

- Remove the bracket and pedal assembly.

Installing

Install in reverse order of removal. Note the following:

Follow the Tightening Sequence






- Tighten bolts - 1 - through - 6 - in the same sequence as illustrated.

- Clip the brake pedal to the brake booster; refer to => [ Brake Pedal and Brake Booster, Separating and Connecting ] Brake Pedal and Brake Booster, Separating and Connecting.

Tightening Specification