Rearview Camera System Control Module (J772)

Rearview Camera System Control Module (J772)

Control module is installed in luggage compartment behind right side wall trim inside the luggage compartment.

Removing

- Switch off the ignition and all electrical consumers and remove the ignition key.

- Remove the right side trim panel inside the luggage compartment..

- Release and disconnect the harness connectors - 1 - and - 2 -.






- Press the button - arrow - and remove the rearview camera system control module - 3 - out of the mount.

Installing

Install in reverse order of removal.

Only if the control module was replaced

- Calibrate the system again. Refer to => [ Rearview Camera System, Calibrating ] Rearview Camera System, Calibrating.