Front and Rear Glass Panel Height, Adjusting

Front and Rear Glass Panel Height, Adjusting

• Adjust the front glass sunroof panel only on the front edge and the rear glass sunroof panel on the rear edge.

• To achieve the best possible exterior optical characteristics, make sure that the adjustment on left and right sides is performed as evenly (symmetrically) as possible.

Check the height adjustment

- Use a depth gauge to check the adjustment of the front glass panel - 1 - and the rear glass panel - 2 -.






• Dimension - a -: 1.5 +/- 1 mm

• Dimension - b - : 1 +/- 1 mm

• Dimension - c - : 1 +/- 1 mm

If the measured values deviate from the specified values, then the glass sunroof panel must be adjusted accordingly.

• Adjust the front glass sunroof panel

• Adjust the rear glass sunroof panel

Adjust the front glass sunroof panel

• The glass panel height adjustment is to be performed after the glass panel has been closed out of sliding position.

- Remove trim. Refer to => [ Glass Panel ] Glass Panel

- Only loosen both front left and right screws - 2 - for the glass panel - 1 -.






- Close the glass panel.

- Adjust the glass panel - 1 - according to the illustration.






• Dimension - a -: 1.5 +/- 1 mm

• Dimension - b - : 1 +/- 1 mm

• Dimension - c - : 1 +/- 1 mm

- Tighten the left and right screws to 5 Nm.

- Install the trim.

Adjust Rear Glass Sunroof Panel

- Gently pull the inner seal - 3 - toward the inside on the marked locations - arrow - and loosen the screws - 2 - for the rear glass panel - 1 -.






- Adjust the rear glass panel - 2 - according to the illustration.






• Dimension - a -: 1.5 +/- 1 mm

• Dimension - b - : 1 +/- 1 mm

• Dimension - c - : 1 +/- 1 mm

- Tighten the screws to 5 Nm.