Cam Chain Removal
Cam Chain Removal
NOTE: Keep the cam chain away from magnetic fields.
1. Remove the front wheels.
2. Remove the splash shield Front Splash Shield Replacement.
3. Remove the drive belt Service and Repair.
4. Remove the cylinder head cover Cylinder Head Cover Removal.
5. Set the No. 1 piston at top dead center (TDC). The punch mark (A) on the variable valve timing control (VTC) actuator and the punch mark (B) on the exhaust camshaft sprocket should be at the top. Align the TDC marks (C) on the VTC actuator and exhaust camshaft sprocket.
6. Remove the VTC oil control solenoid valve VTC Oil Control Solenoid Valve Removal/Test/Installation.
7. Remove the crankshaft pulley Service and Repair.
8. Support the engine with a jack and a wood block under the oil pan.
9. Remove the torque rod stiffener (A) and upper torque rod (B).
10. Remove the ground cable (A), then remove the side engine mount bracket (B).
11. Remove the water bypass pipe mounting bolt (A), then remove the engine mount bracket (B).
12. Remove the cam chain case.
13. Loosely install the crankshaft pulley.
14. Turn the crankshaft counterclockwise to compress the auto-tensioner.
15. Align the holes on the lock (A) and the auto-tensioner (B), then insert a 1.5 mm (0.06 in) diameter pin or lock pin (P/N 14511-PNA-003) (C) into the holes. Turn the crankshaft clockwise to secure the pin.
16. Remove the auto-tensioner.
17. Remove the cam chain guide B.
18. Remove the cam chain guide A and tensioner arm (B). Inspect the tensioner and the guide, and replace then if needed.
19. Remove the cam chain.