Readiness Code Reading
Readiness Code, Checking
NOTE: The readiness code will be erased:
- When Diagnostic Trouble Code (DTC) memory is erased
- When the Engine Control Module (ECM) harness connector is disconnected (e.g to connect VAG 1598/22 test box)
- When the battery is disconnected
Required special tools and test equipment
- VAG 1551 Scan Tool (ST) with adapter cable VAG 1551/3
Checking
- Connect VAG 1551/VAG 1552 Scan Tool (ST) and press buttons -0- and -1- to insert "Engine Electronics" address word 01 (with ignition switched on). Connecting VAG 1551/1552 Scan Tool
Indicated on display
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -8- to select "Read Measuring Value Block" function 08, and press -Q- button to confirm input.
Indicated on display
Read Measuring Value Block HELP
Input display group number XXX
- Press buttons -0-, -8- and -6- to input display group number 86, and press - Q- button to confirm input.
Indicated on display (1-4 = display fields)
Read Measuring Value Block 86 ->
1 2 3 4
- Check readiness code values in display field 1.
Specified value: 00000000
NOTE: The readiness code is generated as soon as only zeros ("0") are shown in display field 1.
- Press -> button to advance program sequence.
Indicated on display
Rapid data transfer HELP
Select function XX
- Press buttons -0- and -6- to select "End Output" function 06, and press - Q- button to confirm input.
If the readiness code was not generated, generate readiness code again. Readiness Code, Generating
- Check readiness code. If DTC memory has been erased, or ECM has been disconnected from B+, generate readiness code again.
Readiness Code Reading
Readiness Code, Generating
Explanation of 8-digit readiness code