Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2005 >> A4 Cabriolet (8H7) L4-1.8L Turbo (AMB) >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Testing and Inspection >> Monitors, Trips, Drive Cycles and Readiness Codes >> Audi Drive Cycle/Readiness Code >> With Generic Scan Tool >> Read Readiness Code

Read Readiness Code



Read Readiness Code

Test requirements:
- No DTCs in DTC memory; Check DTC memory. Mode 3: Check DTC Memory
- Coolant temperature at least 80 degree C see "Mode 1: Check measuring values "; "PID 05: Coolant temperature", Mode 1: Check Measured Values

Procedure
- Connect diagnostic tester. Connect Diagnostic Tester
- Start engine and let run at idle.
- In diagnostic function "33 - OBD", select "Mode 1: Checking measured values."
- Select the desired measuring value "PID 01".
- Observe the right 8-digit number block:

If all diagnoses have run through successfully, the following specified value 8-digit number block must appear:

Specified value: 0 0 0 0 0 0 0 0

Evaluation PID 01: System status-information (right 8-digit number block:)







If a 1 is displayed instead of a 0 in the 8-digit number block:
- Generate readiness code. Readiness Code, Generating
pro multis · About Operation CHARM