Ribbed Belt and Assembly Bracket Overview

Ribbed Belt and Assembly Bracket Overview

• Before removing the ribbed belt, mark the turning direction on it with chalk or a felt tip pen. A reversed turning direction can cause damage to the belt under operating conditions. When installing, make sure the belt is correctly seated in the belt pulley.






1 Belt Pulley

• For the ribbed belt

• Removing and installing, refer to => [ Vibration Damper ] Service and Repair

2 Special Bolt

• Replace, refer to the electronic parts catalog ETKA

• 20 Nm plus an additional 90° turn

3 Bolt

• 23 Nm

4 Ribbed Belt Tensioning Damper

• To release tension on ribbed belt, pivot using open-end wrench.

• Secure tensioner with special tool locking pin (T10060A)

5 Bracket for Assemblies

• Removing and installing, refer to => [ Accessory Assembly Bracket ] Service and Repair

6 Bolt

• 23 Nm

7 Bolt

• 23 Nm

8 Generator

• Moving the threaded bushings on the generator slightly to the rear will make is easier to install the generator.

9 Bolt

• Insert with locking fluid

• Locking fluid, refer to the electronic parts catalog ETKA

• Follow the tightening sequence, refer to => [ Accessory Assembly Bracket ] Service and Repair

10 Bushing

• 2 pieces

11 Bolt

• 25 Nm

12 Air Conditioner (A/C) Compressor

13 Ribbed Belt

• Check for wear

• Do not kink

• Removing and installing, refer to => [ Ribbed Belt ] Ribbed Belt

Ribbed Belt Routing





Accessory Assembly Bracket Tightening Sequence





- Install bolts - 1 through 6 - and tighten by hand.

- Tighten bolts - 1 through 6 - to 40 Nm.