Trapezoidal Control Arm, Upper Control Arm, Tie Rod, Coil Spring and Level Control System Sensor Assembly Overview
Trapezoidal Control Arm, Upper Control Arm, Tie Rod, Coil Spring and Level Control System Sensor Assembly Overview
1 Upper Transverse Link
• Removing and installing, refer to => [ Upper Transverse Link ] Upper Transverse Link.
2 Eccentric Washer
3 Nut
• 95 Nm
• Always replace if removed.
4 Wheel Bearing Housing
5 Nut
6 Trapezoidal Control Arm
• Removing and installing, refer to => [ Trapezoidal Control Arm ] Trapezoidal Control Arm.
7 Bolt
• 85 Nm + 90° turn
• Always replace if removed.
8 Bolt
• 25 Nm
9 Stone Deflector for Trapezoidal Control Arm
10 Lower Spring Support
11 Coil Spring
• Note different types of suspension versions, see vehicle data plate. Refer to => [ Production Control Number (PR Number), Explanations ] Application and ID.
• Removing and installing, refer to => [ Coil Spring ] Coil Spring.
12 Upper Spring Support
13 Upper Spring Seat Spacer Washer
• Only installed on vehicles with heavy duty suspension.
14 Subframe
15 Nut
• 95 Nm
• Always replace if removed.
16 Shim
17 Eccentric Bolt
18 Bolt
• 10 Nm
19 Bolt
• 5 Nm
20 Bolt
• 85 Nm + 90° turn
• Always replace if removed.
21 Securing Clip
22 Left Rear Level Control System Sensor
• Complete with components.
• Sensor lever must point toward outside.
• Replace in vehicle. Refer to => [ Rear Vehicle Level Sensor ] Rear Vehicle Level Sensor.
• After loosening, check basic setting of headlamp adjustment.
• After loosening, control position must be adapted anew in vehicles with air spring suspension. Refer to => [ Self-Leveling Suspension Control Position, Programming ] Self-Leveling Suspension Control Position, Programming.
23 Bolt
• 85 Nm + 90° turn
• Always replace if removed.
24 Stone Protection Plate
• Only installed on vehicles with heavy duty suspension.
25 Locking Clip
26 Tie Rod
• Removing and installing, refer to => [ Tie Rod ] Service and Repair.
27 Bolt
• 85 Nm + 90° turn
• Always replace if removed.
28 Eccentric Bolt