Operation CHARM: Car repair manuals for everyone.

Entry Assistance Release Cable B







Entry Assistance Release Cable B

Removing

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.

Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Turn on the ignition.

- Disconnect the ground cable from the battery.

- Remove the front seat:

Standard seat and Sport seat (manual). Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

- Attach the front seat to the fixture for seat repair (VAS 6136). Refer to => [ Front Seat, Installing on the ] Front Seat, Installing on the Fixture For Seat Repair (VAS 6136).

- Move the backrest forward as far as the stop using the handwheel.

- Disengage the eyelet on the entry assistance release cable B - 3 - from the pin - arrow - on the seat rail.






- Unclip the entry assistance release cable B - 3 - at the seat forward/back adjuster - 2 -.

- Push the upholstery to the side.

- Disengage the eyelet on the entry assistance release cable B - 1 - from the pin - arrow - on the backrest hinge.






- Disengage the retainer on the entry assistance release cable B at the backrest hinge and remove the cable.

Installing

Follow all safety precautions when working on pyrotechnic components. Refer to => [ Safety Precautions ] Service Precautions.

Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Make sure the backrest is in the basic position, i.e. it must be moved forward as far as the stop using the handwheel.

- Engage the eyelet on the entry assistance release cable B - 1 - from the pin - arrow - on the backrest hinge.






- Secure the entry assistance release cable B on the backrest hinge.

- Clip the entry assistance release cable B - 3 - in at the seat forward/back adjuster - 2 -.






- Engage the eyelet on the entry assistance release cable B - 3 - from the pin - arrow - on the seat rail.

- Adjust the entry assistance release cable B. Refer to => [ Entry Assistance Release Cable B, Adjusting ] Entry Assistance Release Cable B, Adjusting.

Further installation is performed in reverse sequence of removal, but observe the following:

Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground (GND) cable with the ignition turned on.

If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the vehicle diagnostic tester.