4-Pin Relay/Fuse Panel With Threaded Connection

4-Pin Relay/Fuse Panel with Threaded Connection

Removing

- Switch off ignition and remove ignition key.

- Remove the driver side instrument panel cover.

- Disengage the 3-pin relay/fuse panel by pressing the retaining springs in the - direction of the arrow - and remove the relay/fuse panel - 1 -.





- Mark the electrical wires - 1 - and - 2 - before removing so they can be installed later.





- Remove the electrical wire - 1 - on the 4-pin relay/fuse panel.

- Release the retaining spring - arrow A - and tilt the relay/fuse panel - 3 - out of the mount - arrow B -.

- On the rear side, remove the electrical wire - 2 - on the 4-pin relay/fuse panel.

- Unclip fuse panel on relay carrier.

- Remove the relay and control modules.





- Release the retaining clips - arrows - and press the relay carrier - 2 - back and out of the bracket - 1 -.

• The exact assignment of the 4-pin relay/fuse panel with threaded connection can be found in the applicable wiring diagram.

Installing

• Tightening specification => [ 4-pin relay/fuse panel with
threaded connection, tightening specifications ] Relay Carrier and Fuse Panel In Instrument Panel and A-Pillar Assembly Overview.

Install in reverse order of removal, observing the following:

- Install driver's storage compartment.