Timing Chain Covers Overview
Timing Chain Covers Overview
1 Bolt
• Replace
• Tightening specification and sequence, refer to => [ Lower Timing Chain Cover, Tightening Specifications and Sequence ]
2 Shaft Seal
• For the crankshaft, transmission side
• Removing and installing, refer to => [ Crankshaft Seal ] Service and Repair
3 Bolt
• Replace
• Tightening specification and sequence, refer to => [ Lower Timing Chain Cover, Tightening Specifications and Sequence ]
4 Alignment Bushing
• 2 pieces
5 Threaded Pin
• Tightening specifications, refer to => [ Lower Timing Chain Cover, Tightening Specifications and Sequence ]
6 Left Cylinder Head Gasket
7 Bolt
• Replace
• Tightening specification and sequence, refer to => [ Left Timing Chain Cover, Tightening Specifications and Sequence ]
8 Bracket
• For heat shield
9 Left Timing Chain Cover
• Removing and installing, refer to => [ Left and Right Timing Chain Covers ] Left and Right Timing Chain Covers
10 Bracket
• For wiring harness
11 Bolt
• Replace
• Tightening specification and sequence, refer to => [ Left Timing Chain Cover, Tightening Specifications and Sequence ]
12 Bracket
• For the left oxygen sensors electrical connectors
13 Bolt
• Tightening specification and sequence, refer to => [ Left Timing Chain Cover, Tightening Specifications and Sequence ]
14 Seals
• Replace
15 Bracket
• For the right oxygen sensors electrical connectors
16 Bolt
• Tightening specification and sequence, refer to => [ Left Timing Chain Cover, Tightening Specifications and Sequence ]
17 Bolt
• Tightening specification and sequence, refer to => [ Right Timing Chain Cover, Tightening Specifications and Sequence ]
18 Bracket
• For the electrical connectors
19 Right Timing Chain Cover
• Removing and installing, refer to => [ Left and Right Timing Chain Covers ] Left and Right Timing Chain Covers
20 Right Cylinder Head Gasket
21 Bracket
• For heat shield
22 Bolt
• Replace
• Tightening specification and sequence, refer to => [ Right Timing Chain Cover, Tightening Specifications and Sequence ]
23 Alignment Bushing
• 2 pieces
24 Bolt
• Tightening specification and sequence, refer to => [ Lower Timing Chain Cover, Tightening Specifications and Sequence ]
25 Lower Timing Chain Cover
• Removing and installing, refer to => [ Lower Timing Chain Cover ] Lower Timing Chain Cover
26 Engine Speed (RPM) Sensor (G28)
27 Bolt
Left Timing Chain Cover, Tightening Specifications and Sequence
• Replace bolts which have been tightened to an additional torque.
• The brackets - arrows A, B - are connected with the left timing chain cover.
- Tighten the bolts in 2 steps according to the tightening sequence:
Right Timing Chain Cover, Tightening Specifications and Sequence
• Replace bolts which have been tightened to an additional torque.
• The brackets - arrows A and B - are attached to the right timing chain cover.
- Tighten the bolts in 2 steps according to the tightening sequence:
Lower Timing Chain Cover, Tightening Specifications and Sequence
• Replace bolts which have been tightened to an additional torque.
- Tighten bolts in 8 stages as follows:
