Electronic Brake Control Module: Service and Repair

Electronic Brake Control Module Replacement

Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution (Brake Fluid Irritant Caution).

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice (Brake Fluid Effects on Paint and Electrical Components Notice).


Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON position.


1. Turn the ignition switch to the OFF position.
2. Remove the fuel injector sight shield, 3.8L engine only. Refer to Fuel Injector Sight Shield Replacement (Service and Repair).
3. Remove the front fender upper diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement (Service and Repair).
4. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement (Service and Repair) for the 3.8L engine or Air Cleaner Inlet Duct Replacement (Service and Repair) for the 3.6L (LY7) engine.




5. Disengage the locking tab (1) from the electronic brake control module (EBCM) harness connector.
6. Disconnect the EBCM harness connector.
7. Remove any dirt/debris from the assembly.




8. Remove the 6 EBCM to brake pressure modulator valve (BPMV) retaining bolt/screws.

Important: Do not pry apart using a tool. Be careful not to damage BPMV surface.



Important: Care must be taken not to damage the solenoid valves when the EBCM is removed from the BPMV.


9. Separate the EBCM (1) from the BPMV (4) by gently pulling apart until separated.
10. Disconnect the pump motor connector (3) at the bottom of the EBCM.



Installation Procedure





1. Connect the pump motor connector (3) to the bottom of the EBCM.
2. Install the EBCM (1) to the BPMV (4).

Notice: Refer to Fastener Notice (Fastener Notice).

3. Install the 6 EBCM to BPMV retaining bolt/screws (2).

Tighten the retaining bolt/screws to 2.9 N.m (26 lb in).





4. Connect the EBCM harness connector.
5. Reengage the locking tab (1) to the EBCM harness connector.
6. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement (Service and Repair) for the 3.8L engine or Air Cleaner Inlet Duct Replacement (Service and Repair) for the 3.6L (LY7) engine.
7. Install the front fender upper diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement (Service and Repair).
8. Install the fuel injector sight shield, 3.8L engine only. Refer to Fuel Injector Sight Shield Replacement (Service and Repair).
9. Turn the ignition switch to the RUN position, do not start engine.
10. Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview).
11. Refer to Control Module References (Programming and Relearning) for programming and setup information.