Front Door Window Regulator: Service and Repair

Front Side Door Window Regulator Replacement

Removal Procedure

Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

1. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (Service and Repair).
2. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement (Service and Repair).

Notice: Refer to Paint Damage Notice.

3. Apply masking tape to the outer reveal.




4. Raise the window far enough in order to gain access through the inner door panel to the window guide retainer clip.
5. Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
6. Raise the window to the full up position and tape in place.
7. Disconnect the electrical connector from the power window motor by pulling up on the tab to release it.




8. Remove the bolt from the window regulator motor (3).
9. Remove the nuts (2, 4) from the window regulator studs.
10. Remove the window regulator and motor through the access opening in the inner door panel.
11. Remove the power window motor from the window regulator. Refer to Front Side Door Window Regulator Motor Replacement (Service and Repair).

Installation Procedure

1. Install the power window motor to the window regulator. Refer to Front Side Door Window Regulator Motor Replacement (Service and Repair).




2. Install the window regulator and motor through the access opening in the inner door panel.
3. Install the nuts (2, 4) to the window regulator studs.
4. Install the window regulator motor bolts (3).

Notice: Refer to Fastener Notice.

5. Tighten the window regulator bolt and nuts to the door.

Tighten the bolt and nuts to 10 N.m (89 lb in).




6. Connect the electrical connector to the power window motor and push in on the tab to lock in place.
7. Remove the masking tape.
8. Lower the window far enough in order to gain access through the inner panel to the window guide retainer to snap the window into the retainer.
9. Inspect the window for proper operation and programming. Refer to Window Regulator Motor Programming and Setup (Programming and Relearning).
10. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement (Service and Repair).
11. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement (Service and Repair).