B2615
DTC B2615
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B2615 00
- Passenger Compartment Dimming 2 Circuit
Diagnostic Fault Information
Circuit/System Description
Battery voltage for the courtesy lamps is supplied at all times, from the CTSY/RF TRN Fuse located in the rear fuse block, to the body control module (BCM). When the BCM receives a signal to command the courtesy lamps ON, it then applies voltage through the courtesy lamps supply voltage circuits to the courtesy lamps.
Conditions for Running the DTC
* The BCM attempts to illuminate the courtesy lamps.
* Engine ON, the BCM attempts to illuminate the day time running lamps.
* Ignition ON with the right turn signal switch active, the BCM attempts to illuminate the right front turn signal.
Conditions for Setting the DTC
* The BCM detects a short to ground on the courtesy lamp supply voltage circuit.
* The BCM detects a short to ground on the right front turn signal supply voltage circuit.
Action Taken When the DTC Sets
The BCM will not attempt to activate courtesy lamps or the right front turn signal.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.
Reference Information
Schematic Reference
Interior Lights Schematics (Interior Lights Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Interior Lighting Systems Description and Operation (Interior Lighting Systems Description and Operation)
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing For Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, command the Courtesy Lamps ON and OFF with a scan tool. The courtesy lamps should turn ON and OFF when changing between commanded states.
Circuit/System Testing
Note: Each courtesy lighting component may need to be disconnected to isolate a short to voltage or short to ground. Use the schematic to identify the following:
* Lighted components the vehicle is equipped with.
* Component locations on the passenger compartment dimming control circuit
* Each component's control and ground circuit terminals
1. Ignition OFF, disconnect the harness connector at any component with inoperative lighting.
2. Ignition OFF, scan tool disconnected, interior lamps OFF, doors CLOSED, test for less than 5 ohm between the ground circuit and ground.
• If greater than the specified value, test the ground circuit for an open/high resistance.
3. Connect a test lamp between the control circuit and ground.
4. Command the Courtesy Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
• If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
• If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
5. If all circuits test normal, test or replace the component with the inoperative lighting.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Door Courtesy Lamp and Reflector Replacement (Door Courtesy Lamp and Reflector Replacement)
* Roof Rail Rear Courtesy Lamp Replacement (Roof Rail Rear Courtesy Lamp Replacement)
* Control Module References (Programming and Relearning) for BCM replacement, setup, and programming