C1111

Inspection 8: Actuator Motor System
DTC C1111, C1140

Inspection Procedure
1. CHECK SELF-DIAGNOSIS RESULTS (1)





Check the self-diagnostic results.

Is the above displayed in the self-diagnostic display items?
YES >> GO TO 2.
NO >> Inspection is completed.

2. CHECK SELF-DIAGNOSIS RESULTS (2)
1. Disconnect ABS actuator and electric unit (control unit) connector E56. Then reconnect it securely.
2. Perform self-diagnosis again.

Do any self-diagnosis item appear?
YES >> GO TO 3.
NO>> Poor connection. Repair or replace the applicable connector.

3. CHECK ABS MOTOR AND MOTOR RELAY POWER SYSTEM
1. Disconnect ABS actuator and electric unit (control unit) connector E56.








2. Check voltage between ABS actuator and electric unit (control unit) harness connector E56 and ground.








3. Check continuity between ABS actuator and electric unit (control unit) harness connector E56 and ground.

OK or NO
OK >> Perform self-diagnosis again. If the same result appears, replace ABS actuator and electric unit (control unit). Refer to "ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)" C1109.
NO >> Repair harness or connectors.