Scan Tool Testing and Procedures
CONSULT-III MAIN FUNCTIONCONSULT-III can display each diagnostic item using the diagnostic test modes shown following.
Self-Diagnosis
OPERATION PROCEDURE
Before performing the self-diagnosis, start engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute.
ERASE MEMORY
After erasing DTC memory, start engine and drive vehicle at 30 km/h (19 MPH) or more for approximately 1 minute as the final inspection, and make sure that the ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake warning lamp turn OFF.
CAUTION:
If memory cannot be erased, perform applicable diagnosis.
NOTE:
^ When the wheel sensor malfunctions, after inspecting the wheel sensor system, the ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp and brake waning lamp will not turn OFF even when the system is normal unless the vehicle is driving at approximately 30 km/h (19 MPH) or more for approximately 1 minute.
^ Brake warning lamp will turn ON in case of parking brake operation (when switch is ON) or of brake fluid level switch should not stay "ON" position.
^ VDC OFF switch should not stay "ON" position.
DISPLAY ITEM LIST (Part 1):
DISPLAY ITEM LIST (Part 2):
Data Monitor
DISPLAY ITEM LIST (Part 1):
DISPLAY ITEM LIST (Part 2):
Active Test
CAUTION:
^ Do not perform active test while driving vehicle.
^ Make sure to completely bleed air from the brake system.
^ Active test can not be performed when EBD, ABS, TCS or VDC operation is malfunction.
^ ABS and brake warning lamps turn on during the active test.
NOTE:
^ When active test is performed while depressing, the pedal depression amount will change.
^ This is normal. "TEST IS STOPPED" is displayed 10 seconds after operation start.
^ After "TEST IS STOPPED" is displayed, touch "BACK" and perform test again.
TEST ITEM
Solenoid Valve
NOTE:
The example shown is for the front right wheel. The procedure for the other wheels is the same as given below.
^ When performing an active test of the ABS function, select the main item for each test item. In addition, when performing an active test of the VDC/TCS function, select the item menu for each test item.
^ For the ABS solenoid valve, touch "UP" "KEEP" "DOWN", and for the ABS solenoid valve (ACT), touch "UP" "ACTUATOR UP" "ACTUATOR KEEP", and check to make sure that all solenoid valve (in, out) are operating as given in the table below.
ABS Motor
Touch "ON" and "OFF" on the screen. Make sure ABS motor relay operates as shown in table below.
