P0725
P0725 ENGINE SPEED
Description
The engine speed signal is transmitted from the ECM to the TCM with CAN communication line.
DTC Logic
DTC DETECTION LOGIC
DTC DETECTION LOGIC:
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch
OFF. Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for at least 10 consecutive seconds.
VHCL/S SE-A/T : 10 km/h (6 MPH) or more
ACCELE POSI : More than 1.0/8
SLCT LVR POSI : "D" position
Is "P0725" detected?
YES - Go to P0725.
NO - Check intermittent incident. Refer to Intermittent Incident.
Diagnosis Procedure
1.CHECK DTC OF ECM
With CONSULT-III
1. Turn ignition switch ON.
2. Perform "Self Diagnostic Results" in "ENGINE".
Is the inspection result normal?
YES - GO TO 2.
NO - Check DTC detected item. Refer to Testing and Inspection.
2.CHECK DTC OF TCM
With CONSULT-III
Perform "Self Diagnostic Results" in "TRANSMISSION".
Is any DTC other than "P0725" detected?
YES - Check DTC detected item. Refer to Testing and Inspection.
NO - GO TO 3.
3.CHECK THE IGNITION SIGNAL CIRCUIT
With CONSULT-III
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Check for engine speed change corresponding to "ACCELE POSI" while monitoring "ENGINE SPEED".
Is the inspection result normal?
YES - GO TO 4.
NO - Check ignition signal circuit. Refer to Diagnosis Procedure.
4.CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to Main Power Supply and Ground Circuit.
Is the inspection result normal?
YES - Replace the control valve with TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.