P0700

P0700 TRANSMISSION CONTROL





Description
The TCM consists of a microcomputer and connectors for signal input and output and for power supply. The
TCM controls the A/T.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch
OFF. Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Run engine for at least 2 consecutive seconds at idle speed.
3. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST
Follow the procedure "With CONSULT-III".
Is "P0700" detected?
YES - Go to P0700.
NO - Check intermittent incident. Intermittent Incident.




Diagnosis Procedure
1.CHECK DTC
With CONSULT-III
1. Turn ignition switch ON.
2. Perform "Self Diagnostic Results" in "TRANSMISSION".
3. Touch "Erase".
4. Turn ignition switch OFF and wait for at least 10 seconds.
5. Check the DTC again. P0700
Is "P0700" detected again?
YES - Replace the control valve with TCM. Exploded View.
NO - Check intermittent incident. Intermittent Incident.