P0744

P0744 TORQUE CONVERTER





Description
This malfunction is detected when the A/T does not shift into 5GR position or the torque converter clutch does not lock-up as instructed by the TCM. This is not only caused by electrical malfunction (circuits open or shorted) but also by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch
OFF. Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for at least 30 consecutive seconds.





With GST
Follow the procedure "With CONSULT-III".
Is "P0744" detected?
YES - Go to P0744.
NO - Check intermittent incident. Intermittent Incident.




Diagnosis Procedure
1.CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Main Power Supply and Ground Circuit.
Is the inspection result normal?
OK - Replace the control valve with TCM. Exploded View.
NG - Repair or replace damaged parts.