Tilt Switch
TILT SWITCH
Description
ADP steering switch (tilt switch) is equipped to the steering column. The operation signal is input to the automatic drive positioner control unit when the ADP steering switch is operated.
Component Function Check
1. CHECK FUNCTION
1.Select "TILT SW-UP", "TILT SW-DOWN" in "DATA MONITOR" mode with CONSULT.
2.Check tilt switch signal under the following conditions.
Is the inspection result normal?
YES- Inspection End.
NO- Perform diagnosis procedure. Refer to "Diagnosis Procedure" .
Diagnosis Procedure
Regarding Wiring Diagram information, refer to "Wiring Diagram" [1][2]Electrical Diagrams.
1. CHECK TILT SWITCH SIGNAL
1.Disconnect ADP steering switch (tilt switch).
2.Check voltage between ADP steering switch harness connector and ground.
Is the inspection result normal?
YES- GO TO 3.
NO- GO TO 2.
2. CHECK TILT SWITCH CIRCUIT
1.Disconnect automatic drive positioner control unit.
2.Check continuity between automatic drive positioner control unit harness connector and ADP steering switch harness connector.
3.Check continuity between automatic drive positioner control unit harness connector and ground.
Revision: March 20122013 Infiniti JX
Is the inspection result normal?
YES- Replace automatic drive positioner unit. Refer to "Removal and Installation" Service and Repair.
NO- Repair or replace harness.
3. CHECK TILT SWITCH
Refer to "Component Inspection" .
Is the inspection result normal?
YES- GO TO 4.
NO- Replace ADP steering switch (tilt switch). Refer to "Removal and Installation" Service and Repair.
4. CHECK INTERMITTENT INCIDENT
Refer to "Intermittent Incident" Intermittent Incident.
- Inspection End.
Component Inspection
1. CHECK TILT SWITCH
1.Turn ignition switch OFF.
2.Disconnect ADP steering switch (tilt switch).
3.Check continuity between ADP steering switch terminals.
Is the inspection result normal?
YES- Inspection End.
NO- Replace ADP steering switch (tilt switch). Refer to "Removal and Installation" Service and Repair.
Revision: March 20122013 Infiniti JX