Removal and Installation

FRONT COMBINATION LAMP

Removal and Installation


FRONT COMBINATION LAMP

Removal

CAUTION:
Disconnect the battery negative terminal or remove the fuse.
1.Remove front bumper fascia. Refer to "Removal and Installation" Removal and Installation.
2.Release the clips and pawls using a suitable tool and remove hood ledge finisher.
3.Remove front combination lamp bolts.
4.Pull front combination lamp forward.
5.Disconnect the harness connectors from the front combination lamp and remove.
Installation
Installation is in the reverse order of removal.
NOTE:
After installation, perform headlamp aiming adjustment. Refer to "Aiming Adjustment Procedure" Aiming Adjustment Procedure.

XENON BULB

Removal

WARNING:
To prevent burns, never touch the glass surface of the bulb with bare hands because the surface is very hot just after the lamp is turned OFF.

CAUTION:
- After installing the bulb, install the plastic cover and the bulb socket securely for watertightness.
- Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
- Do not leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.
- Disconnect the battery negative terminal or remove the fuse.
Revision: March 20122013 Infiniti JX
1.Release the clips and pawls using a suitable tool and remove hood ledge finisher.





2.Remove the washer tank inlet tube clip (A) from the coolant reservoir and pull the washer tank inlet tube (1) from the washer tank (RH only).
3.Rotate plastic cover counterclockwise and unlock from the front combination lamp.





4.Rotate xenon bulb socket counterclockwise and unlock from the front combination lamp.
5.Remove retaining spring and then remove xenon bulb from the front combination lamp.

CAUTION:
Do not break the xenon bulb ceramic tube when replacing the bulb.
Installation
Installation is in the reverse order of removal.
NOTE:
After installation, perform headlamp aiming adjustment. Refer to "Aiming Adjustment Procedure" Aiming Adjustment Procedure.

PARKING LAMP BULB

Removal
1.Release the clips and pawls using a suitable tool and remove hood ledge finisher.





2.Remove the washer tank inlet tube clip (A) from the coolant reservoir and pull the washer tank inlet tube (1) from the washer tank (RH only).
3.Rotate parking lamp socket counterclockwise and unlock from the front combination lamp.
4.Remove parking lamp bulb from bulb socket.
Installation
Installation is in the reverse order of removal.

FRONT TURN SIGNAL LAMP BULB

Removal
1.Release the clips and pawls using a suitable tool and remove hood ledge finisher.
2.Rotate front turn signal lamp socket counterclockwise and unlock from the front combination lamp.
3.Remove front turn signal lamp bulb from bulb socket.
Installation
Revision: March 20122013 Infiniti JX
Installation is in the reverse order of removal.

FRONT SIDE MARKER LAMP BULB

Removal
1.Release the clips and pawls using a suitable tool and remove hood ledge finisher.
2.Rotate the front side marker lamp socket counterclockwise and unlock from the front combination lamp.
3.Remove the front side marker lamp bulb from the bulb socket.
Installation
Installation is in the reverse order of removal.
Revision: March 20122013 Infiniti JX