Luggage Side Lower Finisher

LUGGAGE FLOOR TRIM

LUGGAGE SIDE LOWER FINISHER : Removal and Installation


REMOVAL

1.Lift up the seat base, tilt seatback forward, and fold down second seat forward.
2.Remove second seat belt anchor. Refer to "SEAT BELT RETRACTOR : Removal and Installation" Removal and Installation.
3.Remove third seat. Refer to "Removal and Installation" Removal and Installation.
4.Remove third seat belt anchor. Refer to "SEAT BELT RETRACTOR : Removal and Installation" Removal and Installation.
5.Remove luggage floor board center and both luggage lower boards. Refer to "LUGGAGE FLOOR REAR BOARD : Removal and Installation" Luggage Floor Rear Board.
6.Remove luggage rear plate. Refer to "LUGGAGE REAR PLATE : Removal and Installation" Luggage Rear Plate.





7.Remove rope hook (1) mounting bolt using a socket wrench (A), and then remove rope hook.





8.Disengage luggage side lower finisher fixing clip (1) using a small flat-bladed screwdriver (A) as shown by the arrow in the figure, and then remove clip.
9.Remove luggage side lower finisher.





1.Disengage luggage side lower finisher (1) fixing clips and pawls.





2.Disconnect luggage room power socket harness connector (LH side only).
3.Disconnect fold down switch harness connector (RH side only).
4.Disconnect reclining switch harness connector (LH and RH).
5.Remove luggage side lower finisher.

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
- Visually check the clips and pawls for deformation and damage during installation. Replace with new ones if necessary.
- When installing luggage side lower finisher, check that clips and pawls are securely fitted in body panel holes, and press them in.