Configuration (Around View Monitor Control Unit)

INSPECTION AND ADJUSTMENT

CONFIGURATION (AROUND VIEW MONITOR CONTROL UNIT) : Special Repair Requirement


1. SAVING VEHICLE SPECIFICATION

CONSULT Configuration
Perform "Before Replace ECU", and save the current vehicle specification in CONSULT.
Is the vehicle specification saved normally?
YES- GO TO 2.
NO- GO TO 4.

2. REPLACE AROUND VIEW MONITOR CONTROL UNIT

Replace around view monitor control unit. Refer to "Removal and Installation" Service and Repair.
- GO TO 3.

3. WRITING VEHICLE SPECIFICATION

CONSULT Configuration
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to around view monitor control unit.
- GO TO 6.

4. REPLACE AROUND VIEW MONITOR CONTROL UNIT

Replace around view monitor control unit. Refer to "Removal and Installation" Service and Repair.
- GO TO 5.

5. WRITE VEHICLE SPECIFICATION

CONSULT Configuration
Select "Manual Configuration", and write the vehicle specification to around view monitor control unit.
NOTE:
Around view monitor control unit does not have any setting items. Selection of items on "Manual Configuration" screen is not required.
- GO TO 6.

6. PERFORM SELF-DIAGNOSIS

CONSULT Self Diagnostic Result
Perform self-diagnosis of CONSULT, and check whether or not DTC U1305 is detected.
Is DTC U1305 detected?
- GO TO 5.
- GO TO 7.

7. OPERATION CHECK

Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.
- WORK END