Removal and Installation

CONTROL CABLE

Removal and Installation


REMOVAL

1.Remove center console assembly . Refer to "Removal and Installation" Removal and Installation.
2.Remove cluster lid C cover and instrument center finisher LH. Refer to "Removal and Installation" Removal and Installation.
3.Shift selector lever in "P" position.
4.Remove control cable from A/T shift selector assembly.
5.Remove control cable from manual lever and control cable mounting bracket.





6.Remove retainer mounting bolts (Black Arrows) according to the following procedure.
a.Separate propeller shaft assembly (front). Refer to "Removal and Installation" . (For 4WD models)
b.Disconnect heated oxygen sensor 2 connectors (bank 1 and bank 2). Refer to "Exploded View" Exploded View.
c.Remove exhaust front tube (RH and LH). Refer to "Exploded View" Exploded View.
d.Remove heat plates above three way catalyst (RH and LH).
e.Remove control cable mounting bracket from A/T assembly.
f.Remove retainer mounting bolts from dash panel.
7.Remove control cable from the vehicle.

INSTALLATION

Note the following, and install in the reverse order of removal.





When installing control cable (1) to A/T shift selector assembly (2), check that control cable is fully pressed in with the ribbed (A) surface facing upward.