G862187T22 : Check For Failure of Optical Fibre to Digital Audio Broadcast/Satellite Radio Module

Pinpoint Tests

NOTE: Visually inspect for any of the following conditions and rectify any fault identified prior to carrying out any tests on the MOST Network.

^ Any sharp bends in the optical fibre harness (check for this before disturbing any module or connector).
^ Incorrect engagement of any optical connectors
^ Incorrect engagement of any electrical connectors
^ Damage to the optical fibre harness (chafing, abrasion, kinking, cuts, break, etc)
^ Incorrect assembly of the optical network
^ Unless otherwise stated, ensure vehicle ignition status is set to 'ON' when carrying out MOST Network tests.

G862187t22 : CHECK FOR FAILURE OF OPTICAL FIBRE TO DIGITAL AUDIO BROADCAST/SATELLITE RADIO MODULE

1. Disconnect MOST connector C4ME43B from the digital audio broadcast/satellite radio module.

^ Is the bright red light visible at harness side of connector C4ME43B pin 1?

->Yes
GO to Pinpoint Test G862187t23.G862187T23 : Check For Failure at Digital Audio Broadcast/Satellite Radio Module

->No
Fault is in optical fibre harness between C4MM22B pin 2 (or C4ME27C pin 2, if bluetooth module not installed) and C4ME43B pin 1, rectify the fault and re-test vehicle.