Removal
POWER DISTRIBUTION: POWER MANAGEMENT CONTROL ECU: REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.
Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH Removal
3. REMOVE COWL SIDE TRIM BOARD RH Removal
4. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal
5. REMOVE FRONT NO. 2 CONSOLE BOX INSERT Removal
6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
7. REMOVE INSTRUMENT SIDE PANEL RH Removal
8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal
9. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Removal
10. REMOVE LOWER INSTRUMENT COVER LH Removal
11. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Removal
12. REMOVE INSTRUMENT PANEL BOX DOOR COVER Removal
13. REMOVE INSTRUMENT PANEL BOX ASSEMBLY Removal
14. REMOVE DCM (TELEMATICS TRANSCEIVER) Removal
15. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY Removal
16. REMOVE ECU INTEGRATION BOX RH
(a) Disconnect all the connectors.
(b) Detach the clamp.
(c) Remove the 2 nuts, bolt and ECU integration box RH.
17. REMOVE POWER MANAGEMENT CONTROL ECU
(a) Detach the 2 claws and remove the power management control ECU.