Removal

SUSPENSION CONTROL: REAR ACTIVE STABILIZER CONTROL ECU: REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE BATTERY SERVICE HOLE COVER LH Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
* After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
4. REMOVE ROPE HOOK Removal

5. REMOVE ROPE HOOK ASSEMBLY Removal

6. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY Removal

7. REMOVE NO. 1 COOLER COVER (w/ Air Conditioning System) Removal

8. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER Removal

9. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

10. REMOVE TOOL BOX (w/o Spare Tire) Removal

11. REMOVE REAR FLOOR FINISH PLATE Removal

12. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH Removal

13. DISCONNECT REAR ACTIVE STABILIZER CONTROL ACTUATOR CONNECTOR





(a) Detach the wire harness clamp.





(b) Disconnect the actuator connector labeled A.

(c) Disconnect the actuator connector labeled B.

(1) Release the lever's lock. (*1)

(2) Press the claw and move the lever in the direction of the arrow in the illustration. (*2)

(3) Disconnect the actuator connector. (*3)

NOTICE:
When disconnecting the actuator connector, do not apply excessive force to the wire harness.

14. REMOVE REAR ACTIVE STABILIZER CONTROL ECU





(a) Remove the 2 bolts and ECU.





(b) Disconnect the ECU connector.

(1) Release the lever's lock. (*1)

(2) Press the claw and move the lever in the direction of the arrow in the illustration. (*2)

(3) Disconnect the ECU connector. (*3)

NOTICE:
When disconnecting the ECU connector, do not apply excessive force to the wire harness.

(c) Disconnect the shielded ground wire connector.

15. REMOVE BRACKET

(a) Remove the 4 screws and bracket.