Key Luggage Compartment Lock-In Prevention Function Does Not Operate

THEFT DETERRENT / KEYLESS ENTRY: SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Entry Function): Key Luggage Compartment Lock-in Prevention Function does not Operate
- Key Luggage Compartment Lock-in Prevention Function does not Operate

DESCRIPTION

If the entry luggage compartment lock-in prevention function does not operate, either of the following may be the cause: 1) communication between the indoor electrical key oscillator (luggage compartment) and certification ECU (smart key ECU assembly) cannot be performed; or 2) a malfunction in the certification ECU (smart key ECU assembly).

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK SMART ACCESS SYSTEM WITH PUSH-BUTTON START (ENTRY LUGGAGE COMPARTMENT OPEN FUNCTION)

(a) Check that the entry luggage compartment open function operates.

Result:

A -- GO TO OTHER PROBLEM Luggage Compartment Door Entry Unlock Function Does Not Operate When Key Is Outside Luggage Compartment
B -- Continue to next step.

2. CHECK WAVE ENVIRONMENT

(a) Bring the electrical key transmitter near the indoor electrical key oscillator (luggage compartment), and check that the entry luggage compartment lock-in prevention function operates.

NOTICE:
If the key is brought within 0.2 m (0.656 ft.) of the indoor electrical key oscillator (luggage compartment), communication is not possible.

HINT
* When the electrical key transmitter is brought near the indoor electrical key oscillator (luggage compartment), the possibility of wave interference decreases, and it can be determined if wave interference is causing the problem symptom.
* If the operation check is normal, the possibility of wave interference is high. Also, added vehicle components may cause wave interference. If installed, remove them and perform the operation check.

OK:

Entry functions operate normally.

NG -- PERFORM KEY DIAGNOSTIC MODE INSPECTION

OK -- AFFECTED BY WAVE INTERFERENCE

3. PERFORM KEY DIAGNOSTIC MODE INSPECTION

(a) Diagnostic mode inspection (indoor electrical key oscillator (luggage compartment))

(1) Connect the Techstream to the DLC3.

(2) Turn the engine switch on (IG).

(3) Turn the Techstream on.

(4) Enter the following menus: Body Electrical / Utility / Smart Access / Communication Check (Key Diag mode) / Overhead + Luggage (inside).

(5) When the electrical key transmitter is held at the same height as the rear bumper upper surface and aligned with the center of the rear of the vehicle, check that the wireless door lock buzzer sounds.

HINT
If the buzzer sounds, it can be determined that the luggage compartment interior transmitter is operating normally.

OK:

Wireless door lock buzzer sounds.

NG -- CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - INDOOR ELECTRICAL KEY OSCILLATOR)

OK -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal

4. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - INDOOR ELECTRICAL KEY OSCILLATOR)

(a) Disconnect the certification ECU (smart key ECU assembly) connector.

(b) Disconnect the indoor electrical key oscillator (luggage compartment) connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. REPLACE INDOOR ELECTRICAL KEY OSCILLATOR (LUGGAGE COMPARTMENT)

(a) Replace the indoor electrical key oscillator (luggage compartment) Removal.

NEXT -- Continue to next step.

6. CHECK INDOOR ELECTRICAL KEY OSCILLATOR (OPERATION)

(a) Check that the entry function operates normally Operation Check.

OK:

Entry function operates normally.

NG -- REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) Removal

OK -- END (INDOOR ELECTRICAL KEY OSCILLATOR IS DEFECTIVE)