Installation

DOOR / HATCH: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Pass the hood lock control cable assembly into the engine compartment.

(b) Pass the cable through the upper radiator support.

(c) Engage each clamp.

2. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)

(a) Apply MP grease to the sliding areas of the lock.

(b) Connect the hood lock control cable.

(c) Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Install a new hood lock nut cap.

(e) Engage the clamp.

(f) Connect the connector.

4. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.

5. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Installation

6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

8. INSTALL FRONT DOOR SCUFF PLATE LH Installation

9. INSTALL FRONT FENDER LINER LH

HINT
Use the same procedure for the RH side and LH side Installation.

10. INSTALL FRONT WHEEL LH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

11. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Installation

12. INSTALL FRONT BUMPER ASSEMBLY

Installation

13. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

Adjustments

14. INSPECT HOOD SUB-ASSEMBLY Testing and Inspection

15. ADJUST HOOD SUB-ASSEMBLY

Adjustments