Removal

AIR CONDITIONING: COMPRESSOR: REMOVAL

1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE FRONT WHEEL RH

4. REMOVE FRONT FENDER APRON SEAL RH

5. REMOVE COOL AIR INTAKE DUCT SEAL Removal

6. REMOVE ENGINE ROOM SIDE COVER LH Removal

7. REMOVE ENGINE ROOM SIDE COVER RH Removal

8. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

9. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

10. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

11. REMOVE ENGINE UNDER COVER LH

12. REMOVE ENGINE UNDER COVER RH

13. DRAIN ENGINE COOLANT Testing and Inspection

14. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

15. REMOVE NO. 2 AIR CLEANER INLET

16. REMOVE NO. 1 AIR CLEANER INLET

17. REMOVE RADIATOR GRILLE PROTECTOR Removal

18. REMOVE FRONT BUMPER ASSEMBLY Removal

19. REMOVE FRONT BUMPER ENERGY ABSORBER

20. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System) Removal

21. SEPARATE RADIATOR RESERVE TANK HOSE Removal

22. DISCONNECT RADIATOR HOSE INLET Removal

23. DISCONNECT RADIATOR HOSE OUTLET Removal

24. DISCONNECT NO. 1 OIL COOLER INLET HOSE Removal

25. DISCONNECT NO. 1 OIL COOLER OUTLET HOSE Removal

26. REMOVE RADIATOR SUPPORT UPPER Removal

27. REMOVE FAN SHROUD Removal

28. REMOVE RADIATOR ASSEMBLY Removal

29. REMOVE V-RIBBED BELT Removal

30. REMOVE GENERATOR ASSEMBLY Removal

31. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

(a) Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor and pulley.

(b) Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

32. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE

(a) Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose from the compressor and pulley.

(b) Remove the O-ring from the No. 1 cooler refrigerant suction hose.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

33. REMOVE COMPRESSOR AND MAGNETIC CLUTCH

(a) Disconnect the magnetic clutch connector.

(b) Remove the 4 bolts.