Front Power Seat Does Not Operate With Front Power Seat Switch
SEAT: FRONT POWER SEAT CONTROL SYSTEM (w/ Memory): Front Power Seat does not Operate with Front Power Seat Switch
- Front Power Seat does not Operate with Front Power Seat Switch
DESCRIPTION
When a signal is input into the position control ECU built into the front power seat switch LH, the ECU manages the signals received from the front power seat switch, and operates each motor. If the front power seat switch LH receives more than 2 motor operation signals, the motor is stopped. Manual operation is restarted after the front power seat switch LH receives 1 signal only.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
(a) Use the Techstream to check if the CAN communication system is functioning normally How to Proceed With Troubleshooting.
OK:
CAN communication DTC is not output.
NG -- GO TO CAN COMMUNICATION SYSTEM Diagnosis System
OK -- Continue to next step.
2. CHECK FRONT POWER SEAT OPERATION
(a) Check that each function of the power seat operates normally by using the front power seat switch LH Operation Check.
Result:
B -- GO TO OTHER FLOW CHART (One or more Power Seat Motors do not Operate) One Or More Power Seat Motors Do Not Operate
A -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH POWER SOURCE)
(a) Disconnect the T9 connector from the front power seat switch LH.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT POWER SEAT SWITCH LH POWER SOURCE)
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (FRONT POWER SEAT SWITCH LH - BODY GROUND)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (FRONT POWER SEAT SWITCH LH - BODY GROUND)
OK -- REPLACE FRONT POWER SEAT SWITCH LH Removal