Removal

2UR-GSE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: REMOVAL

1. REMOVE ENGINE UNDER COVER

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE NO. 1 AIR CLEANER INLET Removal

4. SEPARATE RADIATOR RESERVE TANK ASSEMBLY Removal

5. REMOVE V-RIBBED BELT Removal

6. REMOVE CRANKSHAFT PULLEY

(a) Using SST, loosen the crankshaft pulley set bolt.





SST : 09213-38010

SST : 09330-00021

HINT
Loosen the crankshaft pulley set bolt until 2 to 3 threads remain threaded to the crankshaft.

(b) Using the pulley set bolt and SST, remove the crankshaft pulley.





SST : 09950-50013

09951-05010

09952-05010

09953-05010

09954-05031

HINT
Apply grease to the threads and tip of the SST center bolt.

7. REMOVE CRANKSHAFT TIMING GEAR KEY

(a) Remove the crankshaft timing gear key from the crankshaft.





8. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

(a) Using a knife, cut through the oil seal lip.





(b) Using a screwdriver with its tip taped, pry out the oil seal.

NOTICE:
After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.