Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Check that the engine switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Temporarily install the curtain shield airbag assembly with the 7 hooks.





NOTICE:
Do not twist the curtain shield airbag assembly when installing it.

(d) Install the 2 clams.





(e) Install 9 new bolts.

Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

HINT
Tighten the bolt in order from 1 to 9.

(f) Connect the curtain shield airbag connector.

NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the procedure from Install Roof Headlining Assembly Installation.