Selector Lever

Selector Lever









Removal

1. Remove the selector lever knob and bezel. For additional information, refer to Selector Lever Bezel Selector Lever Bezel and Selector Lever Knob Selector Lever Knob removal and installation.

2. Disconnect the selector lever cable end from the selector lever.





3. Depress the 2 tabs and remove the selector lever cable from the selector lever.





4. Disconnect the electrical connector.





5. NOTE: Use a paint pen to mark the front and rear position of the selector lever with respect to the console.

Remove the 4 selector lever bolts and the selector lever from the vehicle.





Installation

NOTE: If re-using the selector lever, align the paint marks made on the selector lever and console made during removal.

NOTE: If the selector lever was not marked prior to removal, use Ford service part, selector lever service insert, to align the selector lever.

1. Install the selector lever service inset into the rear center hole in the selector lever on the bottom side of the selector lever. This will make sure of proper alignment of the selector lever to the console.

2. Install the selector lever and the 4 selector lever bolts.
- Tighten to 10 Nm (89 lb-in).





3. Connect the electrical connector.





4. Install the selector lever cable on the selector lever cable retainer.
- Be sure the tabs are locked in place.





5. Connect the selector lever cable end to the selector lever.





6. Install the selector lever bezel and knob. For additional information, refer to Selector Lever Bezel Selector Lever Bezel and Selector Lever Knob Selector Lever Knob removal and installation.

7. Check the selector lever cable adjustment. Make sure that the vehicle starts in PARK and NEUTRAL and the reverse lamps illuminate in REVERSE. If an adjustment is necessary, refer to Selector Lever Cable Adjustment Adjustments.