Shifter M/T: Service and Repair
MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Discharge the refrigerant. Refrigerant Charging
3. Drain the engine coolant. (See Service and Repair)
4. Remove the following parts.
a. Glove compartment Service and Repair
b. Dashboard under cover Dashboard Under Cover Removal/Installation
c. Front scuff plates Front Scuff Plate Removal/Installation
d. Front side trims Front Side Trim Removal/Installation
e. Upper panel Upper Panel Removal/Installation
f. Decoration panel Decoration Panel Removal/Installation
g. Shift lever knob
h. Shift panel Shift Panel Removal/Installation
i. Center panel lower Center Panel Lower Removal/Installation
j. Climate control unit Climate Control Unit Removal/Installation [Full-Auto Air Conditioner] Climate Control Unit Removal/Installation [Manual Air Conditioner]
k. Rear console Rear Console Removal/Installation
l. Hood release lever Service and Repair
m. Lower panel Lower Panel Removal/Installation
n. Driver-side air bag module Driver-Side Air Bag Module Removal/Installation
o. Steering wheel Steering Wheel And Column Removal/Installation [Without Advanced Keyless Entry And Push Button Start System] Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
p. Column cover Service and Repair
q. Combination switch Removal and Replacement
r. Meter hood Meter Hood Removal/Installation
s. Instrument cluster Removal and Replacement
t. Center panel upper Center Panel Upper Removal/Installation
u. Audio unit Audio Unit Removal/Installation
v. Steering shaft cover Steering Wheel And Column Removal/Installation [Without Advanced Keyless Entry And Push Button Start System] Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
w. Steering shaft Steering Wheel And Column Removal/Installation [Without Advanced Keyless Entry And Push Button Start System] Steering Wheel And Column Removal/Installation [With Advanced Keyless Entry And Push Button Start System]
x. Side panel Side Panel Removal/Installation
y. Passenger-side air bag module Passenger-Side Air Bag Module Removal/Installation
z. A-pillar trims A-Pillar Trim Removal/Installation
aa. Cowl grille Cowl Grille Removal/Installation
ab. Dashboard Dashboard Removal/Installation
ac. A/C unit Removal and Replacement
ad. SAS control module Service and Repair
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. After installation, verify that the shift lever can be shifted smoothly into each position.
8. Perform the refrigerant system performance test. Refrigerant System Performance Test
9. Inspect for engine coolant leakage. Engine Coolant Leakage Inspection
Main Shift Cable and Main Select Cable Removal Note
1. Remove the both shift cable end and select cable end using a fastener remover.
Select Cable Installation Note
1. Make sure that the shift lever (transaxle side) is in neutral.
2. Unlock the lock piece of the select cable in the order shown in the figure.
3. Shift the sift lever to neutral.
4. Lock the lock piece of the selector cable in the figure.
5. Shift the shift lever from neutral to other position, and make sure that there are no other components in that area to interfere with the lever.