Rear Door Window Regulator: Service and Repair

REAR POWER WINDOW REGULATOR REMOVAL/INSTALLATION

1. To access the glass installation bolt, adjust the position of the rear door glass that the height of the rear door glass towards the front is approx. 200 mm {7.87 in}.






2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Sail inner garnish Sail Inner Garnish Removal/Installation

b. Rear door garnish

c. Rear door trim Rear Door Trim Removal/Installation

d. Rear door speaker Rear Door Speaker Removal/Installation

e. Rear door glass Service and Repair

4. Remove the nuts.






5. Insert your hand through the rear door speaker installation hole, rotate the drum housing in the direction shown in the figure and disengage the tabs from the rear door module panel.






6. Remove the rear power window regulator from the rear speaker installation hole.






7. Install in the reverse order of removal.

CAUTION:
- When installing, do not allow the cable to come out from the drum housing.