Operation CHARM: Car repair manuals for everyone.

Automatic Transaxle Shift Mechanism Removal/Installation





AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION

CAUTION:
- Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

Selector Lever component Removal/Installation

1. Disconnect the selector lever component connector.
a. Disconnect the negative battery cable.

b. Remove the rear console. Rear Console Removal/Installation

c. Disconnect the selector lever component connector.






2. Remove the selector lever component.
a. Disconnect the selector cable from the selector lever component.






b. Remove the selector lever component.






3. Install in the reverse order of removal.

Selector Cable Removal/Installation

1. Disconnect the negative battery cable.

2. Remove the aerodynamic under cover NO.2. (FS5A-EL) Aerodynamic Under Cover No. 2 Removal/Installation

3. Remove the rear console. Rear Console Removal/Installation

4. Remove the dashboard. Dashboard Removal/Installation

5. Remove the A/C unit. Removal and Replacement

6. Remove the SAS control module. Service and Repair

7. Remove in the order indicated in the table.

8. Install in the reverse order of removal.

9. Adjust the selector cable after having installed.









Selector Cable Adjustment

1. Remove the negative battery cable.

2. Remove the rear console. Rear Console Removal/Installation

3. Shift the selector lever to the P position.

4. Unlock the lock piece of the selector cable (selector lever side) in the order as shown in the figure.






5. Verify that the manual shaft is in the P position.






6. Lock the lock piece and safety lock of the selector cable (selector lever side) in the order as shown in the figure.