P0607

P0607 ECM

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2
communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.


On Board Diagnosis Logic

This self-diagnosis has the one trip detection logic.







DTC Confirmation Procedure

1.Turn ignition switch ON.
2.Check DTC.
3.If DTC is detected, go to Diagnosis Procedure (see below).


Diagnosis Procedure


1. INSPECTION START

With CONSULT
1.Turn ignition switch ON.
2.Select "SELF-DIAG RESULTS" mode with CONSULT.
3.Touch "ERASE".
4.Perform DTC Confirmation Procedure.

5.Is the DTC P0607 displayed again?
With GST
1.Turn ignition switch ON.
2.Select "Service $04" with GST.
3.Perform DTC Confirmation Procedure.
4.Is the DTC P0607 displayed again?
Yes or No
Yes- GO TO 2.
No-INSPECTION END

2. REPLACE ECM

1.Replace ECM.
2.Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Refer to
Special Repair Requirement.
3.Perform VIN Registration.
4.Perform Accelerator Pedal Released Position Learning.
5.Perform Throttle Valve Closed Position Learning.
6.Perform Idle Air Volume Learning.
-INSPECTION END